The problem
A mixer has one main output. Splitting it with Y-cables to many amplifiers loads the output, loses level and picks up noise.
What it does
A distribution amplifier takes one signal and sends identical copies to many outputs, each driven properly. You can run several racks or zones from one mixer.
Balanced or unbalanced
For long cable runs on stage, use balanced XLR outputs: they reject hum. Unbalanced outputs are fine for short runs inside one rack.
Where it goes
Usually after the mixer and crossover, before the amplifiers. In a 4-way system, one distribution amplifier per band output is common.
Products in this guide




DA-20
Distribution Amplifier
One mixer signal, up to 10 stereo or 20 mono amplifiers.
Distribution ampUnbalanced

DAX20
Balanced Distribution Amplifier
Balanced XLR and TRS distribution with 0.004% THD.
Distribution ampBalanced XLR, TRS19 inch

DA1048
8-Way Distribution Amplifier
One input to eight balanced XLR outputs, in 1U.
Distribution ampXLR in, 8 XLR out1U

234-XS
4-Way Crossover
Stereo 2-way and 3-way, or mono 4-way, with 24 dB/oct filters.
CrossoverXLR