Low impedance (2, 4 or 8 ohm)
The amplifier drives a few speakers directly. It suits DJ rigs and stages, where two to four big boxes sit near the rack. Cable runs must be short and thick, because at low impedance a long thin cable wastes a lot of power as heat.
100V (or 70V) line
The amplifier sends a high-voltage, low-current signal. Each speaker has a small transformer with taps, for example 5, 10 or 20 W. You can hang a dozen or more speakers on one pair of wires across a building, and thinner cable works. Temples, schools, factories and campuses use it.
How to size it
Add up the taps you set on every speaker. Keep the total below the amplifier's rated power, with some room spare. Example: 10 column speakers at 10 W and 4 horns at 20 W is 180 W, so a 250 W or 350 W amplifier is right.
Do not mix them
Never connect a plain 8 ohm speaker to the 100V terminals, or a 100V speaker to the 4/8 ohm terminals. Use the output that matches the speaker.



